BXLRFD Downloads
Last revised:
September 17, 2009
Files that use the Adobe PDF format can be viewed using the Adobe
Acrobat Reader
Return to Program Downloads
PENNDOT BXLRFD V2.1.0.1 Program
- September 21, 2009
- The BXLRFD program has been modified to correctly apply
the Barrier Dead Load fromt he LDC command to Cast-In-Place culverts.
Previously, the program would return incorrect live load results for
Cast-In-Place culvert runs that included the Barrier Dead Load input.
This revision only affects Cast-In-Place culverts.
- Only licensed users of BXLRFD v2.1.0.0 will be able to
download BXLRFD v2.1.0.1.
PENNDOT BXLRFD V1.3.0.5 Program
- May 17, 2004
- The serviceability output tables have been revised as
follows: the crack control stress and tensile reinforcement stress is
now converted correctly for US Customary Units; the output show the
corresponding allowable crack control stress for the tensile side of a
section; and now the program always assumes that the concrete section is
cracked.
- The user entered vehicle loads on the SAL Command have
been revised to convert the US Customary Unit loads into tons for correct rating tonnage
output..
- A Live Load Distribution and Dynamic Load Allowance
Table has been added to the program output.
- The User's Manual has been updated to inform the user
that reinforcement commands should not be entered for design runs.
- The program does not report crack control stress values
for the P-82 truck.
- The array used to store the influence line points for
truck load distribution has been increased to accommodate long vehicles on
short span culverts.
- The live load distribution calculations for case 2
(less than 2 ft [600mm] of fill and span greater than 15 ft [4600mm]) have
been modified to include the multiple lane case..
- Only licensed users of BXLRFD v1.3 will be able to
download BXLRFD v1.3.0.5.